Fishing Packs

These wrenches makes presetting our adjustable truck sleeves (24160,24180,24120,24130) easier for the installer. When using the 74400 wrench it is recommended that the opening be equally positioned over the slot opening of the sleeve body.Installation...

This special 10 point socket is needed when removing the O.E rear lower control arm on new 2001 to 2006 Honda Civics, 2003 and up Elements, 2002 to 2006 CRV's and 2002 to 2007 Acura RSX's. Included with part numbers 69300 and 69400.Installation...

The Honda Accord and Acura TSX Rear Adjustable Trailing Arm is an ideal replacement for a damaged OE component, Additionally, it will provide ±1" set-back/wheel base adjustment. This arm is necessary to to correct set-back changes that the 67545...

Our patented thrust alignment plate will allow for corrections of setback and thrust angle on most vehicles with rear leaf springs. Installation is made by loosening the U-bolts holding the leaf spring to the axle, installing the alignment plate...

Use this press tool to remove stuck OE cam sleeves from Toyota trucks. The extended length forcing screw allows you to remove the sleeve without removing the steering rack. Recommended when installing our 25430, 25435, 25440 and 25445 replacement...

This two-piece internally threaded spring compressor is a great option for MacPherson Strut, coilover, and other sccessible springs. With 1-11" of travel and a 2645 lbf (1200kg) max qoekinf load with a 3X safety factor, this is an ideal tool for almost...

Stop wheel hop and vibrations on hub piloted wheels! Hub pilot hole diameter tolerances can allow wheels to be installed and tightened in an "off center" or clocked position. The 32111 threadless wheel centering tool set (3) fits 22mm studs on Heavy Duty...

Improve droop travel, drivability and tire wear as well as adjusting tire position in your wheel well with SPC's adjustable front upper control arms for the Frontier, Pathfinder, and Xterra. Featuring our long life maintainable ball joint and SpecRide...

The upper control arm ball joint pinch bolt on the popular Audi A/S 4, 5, 6, and 7 models is frequently corroded and must be cut out when removing or replacing the upper arms. This bolt & nut replacement kit has 720 hour saltspray certified coating to...

When installing coil spring spacers on many older Ford RWD and some 4WD trucks with Twin I-Beam suspensions, often times the existing spring retainer bolts are not long enough. This 3/4" diameter replacement bolt is 10 inches long, long enough to provide...

For Model # 1000,1001,3000,4000,4100,7000,7700------ On-vehicle lathe 700,705,710----Drum side on 3850 Ammco part # 6914-10-----12 CUT EDGES---- NEGATIVE RAKE 10 bits per pack.

Mishimoto silicone Mustang radiator hose kits for the GT/Cobra are made with a dual layer combining high grade silicone and heat-resistant embedded fibers to provide efficient heat reduction and increased pressure tolerance, all with an OEM replacement...